Sentiotec Pro D Montage- Und Gebrauchsanweisungen Seite 33

Installation instructions, only for experts
Changing the light dimming characteristic
Because incandescent bulbs and LEDs react differently to the dimming function,
it is possible to select the dimming characteristic according to the light system
used. Perform the following steps:
1. Open the technician menu (see Page 31).
2. Select "dl" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired value using the plus button B and the minus button C.
● "bUL" means the dimming characteristic for incandescent bulbs is activated
(standard)
● "LED" means the dimming characteristic for LEDs is activated
5. Confirm the selection by pressing the On/Off button A.
Setting the light operating mode
The light for the sauna cabin can either be dimmed or switched on and off.
Perform the following steps:
1. Open the technician menu (see Page 31).
2. Select "dIL" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired value using the plus button B and the minus button C.
● "on" means that the light is dimmable (standard)
● "oFF" means that the light is switchable
5. Confirm the selection by pressing the On/Off button A.
Setting the fan operating mode
The fan can either be modulated or switched on and off. The dimmer switch
function for the fan is activated as standard. If you wish to deactivate the dimmer
switch function for the fan, perform the following steps:
1. Open the technician menu (see Page 31).
2. Select "FAn" by pressing mode button D.
3. Press the On/Off button A.
4. Select the desired value using the plus button B and the minus button C.
● "on" means that the fan is dimmable (standard)
● "oFF" means that the fan is switchable
5. Confirm the selection by pressing the On/Off button A.
p. 33/62
EN