Creating Your Own User Programs - Sentiotec Pro D Montage- Und Gebrauchsanweisungen

Instructions for use for the user

11.3. Creating your own user programs

You can create user programs as you would like. A preset user program is over-
written in the process. Perform the following steps:
1. Start all functions that are to be switched on with the future user program with
the preferred intensity. Leave the control unit to operate for about 3 minutes.
2. Select the user program symbol 4 by pressing the mode button D.
► The user program symbol lights up.
3. Use the plus button B and minus button C to select which number (1 - 5)
the new user program is to be saved under.
4. Press the plus button B and the minus button C for about 3 seconds.
► The saving of the user program is confirmed with a short flashing of the
user program symbol 4.
► The settings are stored in the selected user program.
Example
User Temperature
program
2
Humidity
°C %
45 55
Auxiliary
Light
output
%
0 50
p. 55/62
Operating
Fan
time
%
Hrs
0 3
EN