Sentiotec Pro D Montage- Und Gebrauchsanweisungen Seite 34

Installation instructions, only for experts
Setting operating mode of the additional output (Pro D2i / Pro D3i only)
The additional output can either be modulated or switched on and off. The dimmer
switch function is activated as standard. If you wish to deactivate the dimmer
switch function for the additional output, perform the following steps:
1. Open the technician menu (see Page 31).
2. Select "IdS" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired value using the plus button B and the minus button C.
● "on" means that the additional output is dimmable/the temperature can
be regulated (standard; max. 500 W - see "Id" page 35)
● "oFF" means that the additional output is switchable (max. 3.5 kW)
5. Confirm the selection by pressing the On/Off button A.
Activating the simultaneous display of the temperature and the humidity
(Pro D3 / Pro D3i only)
To activate simultaneous display (automatic switching between the temperature
and humidity display) of the temperature and humidity, carry out the following steps:
1. Open the technician menu (see Page 31).
2. Select "dUA" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired value using the plus button B and the minus button C.
● "oFF" means the display stays at the selected function (standard)
● "on" means the display switches between temperature and humidity
automatically
5. Confirm the selection by pressing the On/Off button A.
Status output (Pro D3 / Pro D3i only)
You can decide here whether the status output should be activated during sauna
mode or during the post-drying program. Activation during the post-drying program
allows the vaporizer to be drained automatically when a combi heater with an
auto refill function is being used. Then perform the following steps:
1. Open the technician menu (see Page 31).
2. Select "SL" by pressing the mode button D.
3. Press the On/Off button A.
p. 34/62