Product Features - Sentiotec Pro D Montage- Und Gebrauchsanweisungen

Instructions for installation and use

3.3. Product features

Pro D2 / Pro D2 white
The sauna control unit Pro D2 / Pro D2 white features the following functions:
● Regulation of sauna heaters with a heating output of up to 10.5 kW in the
temperature range spanning 30 °C to 110 °C.
● A power booster allows the maximum switching capacity to be increased from
10.5 kW to 18 kW or 30 kW.
● Optional dimming or switching of a cabin light (up to 100 W)
● Optional modulation or switching of a fan (up to 100 W)
● Remote start function
● Door monitoring system
● Status output
● Preset time function
The maximum heating period can be set to 6 h, 12 h, 18 h or 24 h.
● User programs
The user programs enable favourite sauna settings to be saved and accessed
again. There are 5 preset user programs available which can be modified
according to user requirements.
● Automatic heating time limit
The sauna control unit shuts down automatically after the maximum heating
time for safety reasons. The maximum heating period can be set to 6 h, 12 h,
18 h or 24 h.
● Overheat cut-out
The overheat cut-out is installed in the housing for the heater sensor. If a
defect causes the sauna heater to continue heating after reaching the pre-
ferred temperature, the overheat cut-out switches the sauna heater off at a
temperature of around 139 °C.
PRO D3 / PRO D3 white
Same functional scope as the Pro D2 / Pro D2 white, with the following additional
features:
● Regulation of combi-model sauna heaters with a heating output of up to 10.5 kW
and vaporizer output of up to 3.5 kW in the temperature range spanning 30 °C
to 110 °C and a humidity range spanning 0% to 100%.
● Post-drying program
After operation in combined mode, the post-drying program starts automat-
ically to prevent mould or rot from forming in the sauna cabin. This involves
heating the sauna cabin to 80°C with the fan running.
The duration can be set from OFF - 60 minutes.
p. 10/31