Sentiotec Pro D Montage- Und Gebrauchsanweisungen Seite 35

Installation instructions, only for experts
4. Select the desired value using the plus button B and the minus button C.
● "oFF" the status output is activated during the sauna operation (standard)
● "on" the status output is activated during the post-drying program
5. Confirm the selection by pressing the On/Off button A.
Setting mode of the additional output (Pro D2i / Pro D3i only)
Two different modes are available for the additional output:
1. Intensity regulation
2. Room temperature regulation
Perform the following steps to switch between the two modes:
1. Open the technician menu (see Page 31).
2. Select "Ir" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired value using the plus button B and the minus button C.
● "oFF" means intensity regulation (standard; dimmable/switchable see:
Page 34)
● "on" means room temperature regulation (see: Page 45)
5. Confirm the selection by pressing the On/Off button A.
Setting the maximum temperature for the additional output (Pro D2i / Pro
D3i only)
A maximum cabin temperature can be set for the additional output, above which it
automatically switches off. When the temperature falls back below this maximum
temperature, it switches on again.
To set a maximum temperature, carry out the following steps:
1. Open the technician menu (see Page 31).
2. Select "IrH" by pressing the mode button D.
3. Press the On/Off button A.
4. Select the desired value using the plus button B and the minus button
C: settable value: oFF (no maximum temperature specified = standard)
/ 45 / 60/ 70
5. Confirm the selection by pressing the On/Off button A.
p. 35/62
EN