Additional Settings; Pump Kick - Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung

en
14

Additional settings

14.1

Pump kick

Pump kick
Pump kick: ON/OFF
Pump kick: Interval
Pump kick: Speed
Fig. 85: Pump kick
190
displayed in order to monitor the pump status.
The active key lock can be identified in the Home screen by a lock symbol
General settings can be changed under
The following table gives an overview of the "Additional settings" menu:
Universal Display text
1.0 Settings
1.6 Additional settings
1.6.1 Pump kick
1.6.1.1 Pump kick: ON/OFF
1.6.1.2 Pump kick: Interval
1.6.1.3 Pump kick: Speed
1.6.2 Ramp times
1.6.2.1 Ramp times: Start-up time
1.6.2.2 Ramp times: Switch-off period
1.6.4 Automatic PWM
frequency reduction
OFF Switched off
ON Switched on
In order to prevent blocking of the pump, a pump kick is set on the pump. After a set time
interval, the pump starts and switches off after a short time.
Prerequisite:
For the pump kick function, the mains voltage must not be interrupted.
CAUTION
Blockage of the pump due to long downtimes!
Long downtimes may lead to blockage of the pump. Do not deactivate
pump kick!
Via remote control, bus command, control input EXT. OFF or 0 ... 10 V signal, pumps that
have been switched off start up briefly. This prevents blockage after long downtimes.
In the menu "Settings", "Additional settings"
• The pump kick can be switched on and off.
• The time interval for the pump kick can be set between 2 and 72 hours (for factory set-
ting see "Factory setting" [" 198] section).
• The pump speed at which the pump kick is carried out can be set
Universal Display text
1.0 Settings
1.6 Additional settings
1.6.1 Pump kick
1.6.1.1 Pump kick: ON/OFF
1.6.1.2 Pump kick: Interval
1.6.1.3 Pump kick: Speed
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
"Settings", "Additional settings".
.