Factory Setting - Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung

en
16.1

Factory setting

Reset to
factory setting
Confirm
(settings will be lost)
Cancel
Fig. 102: Confirm reset to factory setting
198
NOTICE
Resetting pump settings to factory settings replaces the current pump
settings!
The table gives an overview of the factory settings:
Settings
Set control mode
Setting assistant
Pump On/Off
Twin-head pump operation
Connecting twin-head pump
Twin-head pump alteration
External interfaces
SSM relay
Function SSM relay
Trigger delay
Reset delay
SBM relay
Function SBM relay
Trigger delay
Reset delay
DI1
AI1
AI2
Wilo Net
Wilo Net termination
Wilo Net address
Display setting
Language
Units
Pump kick
Pump kick time interval
Diagnostics and measured
values
Diagnostics help
SSM forced control (normal,
active, inactive)
SBM forced control (normal,
active, inactive)
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
Yonos GIGA2.0
Δp-v
Motor on
Single pump: not connected
Twin-head pump: connected
24 h
Fault(s) only
5s
5s
Motor in operation
5s
5s
active (with cable bridge)
configured
Type of use: differential pres-
sure sensor
Sensor position: pump flange
Signal type: 2 ... 10 V
not configured
switched on
Twin-head pump
Main pump: 1
Pump partner: 2
Single pump: 126
English
3
m, m /h
switched on
24 h
inactive
inactive
Yonos GIGA2.0 ... R1
Basic control mode
n-const.
Motor on
Single pump: not connec-
ted
Twin-head pump: con-
nected
24 h
Fault(s) only
5s
5s
Motor in operation
5s
5s
active (with cable bridge)
not configured
not configured
switched on
Twin-head pump
Main pump: 1
Pump partner: 2
Single pump: 126
English
3
m, m /h
switched on
24 h
inactive
inactive