Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung Seite 158

en
9.4.8 Main menu "Settings"
158
Universal Display text
1
1.1.2 Setpoint
1.1.2 Δp-v, Δp-v
1.1.2 Δp-c, Δp-c
1.1.2 n-c, n-c
1.1.2 PID PID control
1.1.2 Δp-v Setpoint ∆p-v
H set = H target =
1.1.2 Δp-c Setpoint Δp-c
H set = H target =
1.1.2 n-c Setpoint n-c
n act = n is =
1.1.2 PID Setpoint PID
Setpoint = Setpoint =
2
1.1.3 Kp Parameter Kp
2
1.1.4 Ti Parameter Ti
2
1.1.5 Td Parameter Td
2
1.1.6 Control inversion
OFF Inversion OFF
ON Inversion ON
1.1.7 Emergency operation
OFF Pump OFF
ON Pump ON
3
1.1.8 Emergency operation speed
1.1.9 Setpoint source
1.1.9 / 1 Internal setpoint
1.1.9 / 2 Analogue input (AI2)
1.1.9 / 3 CIF module
4
1.1.10 Substitute setpoint
1.1.15 Pump ON/OFF
OFF Switched off
ON Switched on
1.3 External interfaces
1.4 Dual pump management
1.5 Display settings
1.6 Additional settings
1
According to the currently set control mode, only the corresponding setpoint opens.
2
The menu item only opens if the PID control mode is set.
3
The menu item only opens if emergency operation is set to "ON".
4
The menu item only opens if analogue input AI2 is selected as the setpoint source.
Different settings can be changed in the "Settings" menu
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
1
2
2
2
2
3
4
.