Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung Seite 157

Δp-v
Setpoint
Q is = 70.8 m³/h
Fig. 32: Home screen setpoint adjust-
ment Δp-v
9.4.6 Submenu
9.4.7 Main menu "Settings" - Menu
overview
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
Pressing the operating button activates the setpoint adjustment. The frame of the change-
able setpoint turns yellow.
The setpoint is changed by turning the operating button right or left.
Pressing the operating button again confirms the changed setpoint. The pump accepts the
value and the display returns to the main menu.
Pressing the back button
setpoint. The pump shows the main menu with unchanged setpoint.
Active influences of the pump status on the display in the home screen for single pumps
The active influences are listed from highest to lowest priority:
Name
Fault
Pump kick
EXT.OFF
Pump operation OFF
Setpoint OFF
Substitute speed
Fallback Off
No active influences
Table 18: Active influences
Active influences on the hydraulic output - displayed in the home screen
Name
Limitation of the hydraulic output
No active influences
Table 19: Active influences
Each submenu is made up of a list of submenu items.
The title identifies a subsequent submenu or settings dialogue.
The following table gives an overview of the "Settings" main menu:
Universal
1.0
1.1
1.1.1
Δp-v
Δp-c
n-c
PID control
without confirming the changed setpoint will not change the
Displayed sym- Description
bols
Error active, motor stops
Pump kick active
Digital input DI EXT. OFF active
Pump manually switched off
Analogue signal OFF
Pump is running at substitute
speed
Replacement mode active, but set
to motor stop
No active influences active
Dis- Description
played
sym-
bols
Limitation of hydraulic output due to ex-
ternal influences such as too high temper-
ature or insufficient power supply.
- No active influences on the volume flow.
Display text
Settings
Control settings
Control mode
∆p-v
∆p-c
n-c
PID control
en
157