Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung Seite 170

en
Pump cycling
Time-based pump
cycling: ON/OFF
Time-based pump
cycling: Interval
Manual pump cycling
Fig. 54: Pump cycling menu
Dual pump
management
Twin-head pump function
Pump cycling
Pump housing type
Fig. 55: Dual pump management menu
170
"Pump cycling" menu
If a twin-head pump connection has been established, the function can be switched on and
off and the time interval of the pump cycling can be set in the "Pump cycling" menu. Time
interval: between 1 h and 36 h, factory setting: 24 h.
Universal
1.4.4
1.4.4.1
1.4.4.2
1.4.4.3
Confirm
Cancel
An immediate pump cycling can be triggered via the menu item "manual pump cycling".
Manual pump cycling can always be carried out regardless of the configuration of the time-
based pump cycling function.
Menu "Disconnect twin-head pump"
When a twin-head pump function is established, it can also be separated. To do this, select
the following:
Universal
1.0
1.4
1.4.2
Confirm (Pump might re-
set!)
NOTICE
Disconnecting the twin-head pump function fundamentally changes vari-
ous parameters of the pump. The pump is then started automatically.
"Pump housing type" menu
The selection at which hydraulic position a motor head is mounted is made independently of
a twin-head pump connection.
The following selection is available in the "Pump housing type" menu:
• Single pump hydraulics
• Twin-head pump hydraulics I (left in flow direction)
• Twin-head pump hydraulics II (right in flow direction)
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
Display text
Pump cycling
Time-based pump
cycling: ON/OFF
Time-based pump
cycling: Interval
Manual pump
cycling
Confirm
Cancel
Display text
Settings
Dual pump management
Disconnecting twin-head pump
Confirm
(Pump might reset!)