Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung Seite 122

en
Fig. 1: Pump overview
122
No. Component
15 Motor flange
16 Motor shaft
17 Thrower
18 Lantern
19 O-ring
20 Spacer on mechanical seal
21 Impeller
22 Impeller nut
23 Impeller nut washer
24 Pump housing
25 Rotating unit on mechanical seal
26 Stationary ring on mechanical seal
27 Protective plate (only DN 100 ... DN 125)
28 Air vent valve
29 Fastening screws from the motor impeller unit, 4x
30 Transport lug, 2x
31 O-ring of drive
32 Twin-head pump flap
33 Twin-head pump flap shim (only DN 100 ... DN 125)
34 Twin-head pump flap axle (only DN 100 ... DN 125)
35 Axle bore screw plug, 2x (only DN 100 ... DN 125)
36a Retaining ring
36b Retaining ring
37 Key
38 Lantern window
Table 1: Arrangement of the main components
Item Name
1 Transport lugs
2 Pump housing
3 Motor
4 Graphic display
5 Electronic module
6 Electrical fan
7 Protective plate in
front of lantern win-
dow
8 Wilo-Connectivity
Interface
9 Differential pressure
sensor
Table 2: Description of the pump
• Item 3: The motor with mounted electronic module can be rotated relative to the lantern.
Observe the instructions in the "Permitted installation positions and change of the ar-
rangement of components before installation" [" 130] section.
• Item 4: The display can be rotated in 90° steps as required. (See "Turning the display
[" 149]" section).
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
Explanation
Used for transporting and lifting the components. See "In-
stallation" [" 128] section.
Install according to "Installation" [" 128] section.
Drive unit. Forms the drive together with the electronic
module.
Provides information about settings and pump status.
User interface for setting the pump.
Electronic unit with graphic display.
Cools down the electronic module (depending on type).
Protects against rotating motor shaft (DN 100, DN 125 only).
Optional interface
2 ... 10 V with capillary tube connections on flanges of suc-
tion and discharge side