Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung Seite 180

en
180
Set control mode
Δp-v
Δp-c
n-c
PID
Table 30: Application and function of analogue inputs
To change the settings of the analogue inputs, select the following in the menu:
Universal Display text
1.0 Settings
1.3 External interfaces
1.3.3 Analogue input (AI1)
1.3.4 Analogue input (AI2)
The following table gives an overview of the "Analogue input AI1 and AI2" menu:
Universal Display text
1.3.3 Analogue input (AI1)
1.3.3.1 Signal type
1.3.3.2 Pressure sensor range
1.3.3.3 Pressure sensor position
1.3.3.3 / 1 Pump flange
1.3.3.3 / 2 Standard-compliant position
1.3.4 Analogue input (AI2)
1.3.4.1 Signal type
1
Differential pressure measuring points are located at the drilled holes on the pump
flanges of the pump on the discharge and suction side. This sensor position takes into ac-
count a flange correction.
2
Differential pressure measuring points are located in the piping upstream and down-
stream of the pump on the discharge and suction side at a distance from the pump.
24 V DC power supply at the analogue input.
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
Function of analogue input
AI1
Configured as actual value
input
• Type of use: Differential
pressure sensor
Configurable:
• Signal type
• Sensor measuring range
• Sensor position
Configured as actual value
input
• Type of use: Differential
pressure sensor
Configurable:
• Signal type
• Sensor measuring range
• Sensor position
Not used
Configured as actual value
input
• Type of use: any
Configurable:
• Signal type
1
2
Function of analogue input
AI2
Not configured
Can be used as a setpoint
input
Not configured
Can be used as a setpoint
input
Not configured
Can be used as a setpoint
input
Not configured
Can be used as a setpoint
input