Turn Of The Display - Wilo Yonos GIGA2.0-I Einbau- Und Betriebsanleitung

7.6

Turn of the display

Fig. 26: Electronic module
Installation and operating instructions • Wilo-Yonos GIGA2.0-I/-D • Ed.01/2023-03
Pump Wilo Net termination
Pump 1 switched on
Pump 2 switched on
Table 13: Wilo Net cabling
Number of Wilo Net participants:
For twin-head pumps, the Wilo Net consists of two participants, with each individual node
counting as a participant.
• Twin-head pump = 2 participants (e.g. ID 1 and 2)
For further descriptions, see "Application and function of the Wilo Net interface" [" 186]
section.
CAUTION
If the graphic display is not fixed properly and the electronic module is
not installed correctly, protection class IP55 is no longer ensured.
• Ensure that no gaskets are damaged!
The graphic display can be turned in 90° steps. To do this, open the upper part of the elec-
tronic module using a screwdriver.
The graphic display is fixed in position by two snap-in hooks.
1. Carefully open the snap-in hooks with a tool (e.g. screwdriver).
2. Turn the graphic display to the desired position.
3. Fix the graphic display with the snap-in hooks.
4. Fit the upper part of the module again. Observe the screw tightening torques on the
electronic module.
Component Fig./Item screw
(nut)
Electronic module Fig. 26, Item 1
upper part
Fig. I, Item 2
Threaded cable gland Fig. 19, Item 1
union nut
Threaded cable gland Fig. 19, Item 1
Threaded cable gland Fig. 19, Item 6
union nut
Threaded cable gland Fig. 19, Item 6
Power terminals and Fig. 20, 21
control terminals
Earthing screw Fig. 20, Item 5
CIF module Fig. 26, Item 4
Wilo Net address
1
2
Screw drive/ Tightening
thread torque
[Nm] ±10 %
(unless other-
wise stated)
Torx 25/ M5 4.5
External 11
hexagon
socket/ M25
External 8
hexagon
socket/
M25x1.5
External 6
hexagon
socket/
M20x1.5
External 5
hexagon
socket/
M20x1.5
Pusher Slot 0.6x3.5
IP10-slot 1/ 4.5
M5
IP10/ 0.9
PT 30x10
en
Installation
informa-
tion
*
*
*
**
149