Personnel Qualifications; Danger In The Event Of Non-Observance Of The Safety Instructions; Safety Consciousness On The Job; Safety Instructions For The Operator - Wilo BAC Einbau- Und Betriebsanleitung

2.2

Personnel qualifications

2.3 Danger in the event of non-
observance of the safety
instructions
2.4

Safety consciousness on the job

2.5

Safety instructions for the operator

2.6 Safety instructions for installation
and maintenance work
Installation and operating instructions Wilo-BAC
Information applied directly to the product, such as:
• Arrows indicating the direction of rotation,
• Identification for fluid connections,
• Rating plates and
• Warning stickers,
must be strictly complied with and kept in a fully legible condition.
The installation, operating and maintenance personnel must have the
appropriate qualifications for this work. The area of accountability,
responsibility and personnel monitoring are to be ensured by the
operator. If the personnel are not in possession of the necessary
knowledge, they are to be trained and instructed. This can be accom-
plished if necessary by the manufacturer of the product at the request
of the operator.
Non-observance of the safety instructions can result in risk of injury
to persons and damage to the product/unit as well as environmental
hazards. Non-observance of the safety instructions results in the loss
of any claims to damages.
In particular, lack of care may lead to problems such as:
• Danger to persons from electrical, mechanical and bacteriological
influences.
• Pollution of the environment due to leakage of hazardous materials
• Damage to property
• Failure of important product/unit functions
• Failure of required maintenance and repair procedures
The safety instructions included in these installation and operating
instructions, the existing national regulations on accident prevention
together with any internal working, operating and safety regulations
of the operator are to be complied with.
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
• If hot or cold components on the product/unit cause hazards, meas-
ures must be taken by the customer to prevent them from being
touched.
• Guards which prevent moving components (such as the coupling)
from being touched must not be removed whilst the product is in
operation.
• Leakages (e.g. from a shaft seal) of hazardous fluids (e.g. explosive,
toxic or hot) must be led away so that no danger to persons or to the
environment arises. National statutory provisions are to be observed.
• Danger from electrical current must be eliminated. Local directives or
general directives [e.g. IEC, VDE etc.] and local power supply compa-
nies must be adhered to.
The operator must ensure that all installation and maintenance work is
carried out by authorised and qualified personnel, who are sufficiently
informed from their own detailed study of the operating instructions.
Work on the product/unit must only be carried out when at a stand-
still. It is mandatory that the procedure described in the installation
and operating instructions for shutting down the product/unit be
complied with.
English
19