Introduction; Structure Of The Manual; Abbreviations; Illustrations - Wilo EMUport FTS MG Serie Einbau- Und Betriebsanleitung

English

1. Introduction

1.1. About this document
The language of the original operating manual is
German. All other language versions are transla-
tions of the original German manual.
The operating manual contains a copy of the EC
Declaration of Conformity.
Any unauthorized or unapproved changes made
to the design specified in it will nullify this decla-
ration.

1.2. Structure of the manual

The manual is divided into individual sections.
Each section has a heading which clearly
describes its content.
The table of contents also serves as a brief refer-
ence, since all the important sections have their
own headers.
All the important operating and safety instruc-
tions are highlighted. For detailed information
on the structure of these texts, see "Safety" in
section 2.
1.3. Personnel qualifications
All personnel who work on or with the waste wa-
ter pump station must be qualified for such work;
electrical work, for example, may only be carried
out by a qualified electrician. All personnel must
be of legal age.
Operating and maintenance personnel must also
observe the applicable national and international
accident prevention regulations.
It must be ensured that the personnel have read
and understood the instructions in this operating
and maintenance handbook; if necessary, this
manual must be ordered from the manufacturer
in the required language.
This system is not intended to be used by persons
(including children) with limited physical, sensory
or mental capacities or without the experience or
knowledge to do so, unless they are supervised by
a person responsible for their safety and receive
instructions from this person on how to use the
system.
Children must be supervised in order to ensure
that they do not play with the system.

1.4. Abbreviations

Various abbreviations are used in this operating
and maintenance manual.
1.4.1. Abbreviations
• approx. = approximately
• e.g. = for example
• etc. = and so on
• i.e. = that means
• incl. = including
• max. = maximum
• min. = minimum
• p.t.o. = please turn over
• re. = regarding
• s.a. = see also
26

1.5. Illustrations

Dummies and original drawings of the waste wa-
ter pump station are used in the illustrations. This
is the only sensible solution given our wide range
of products and the differing sizes offered by the
modular system. More exact drawings and spec-
ifications can be found on the dimension sheet,
the planning information and the installation plan.

1.6. Copyright

This operation and maintenance manual has been
copyrighted by the manufacturer. The operation
and maintenance handbook is intended for use by
assembly, operating, and maintenance personnel.
It contains technical specifications and diagrams
which may not be reproduced or distributed,
either completely or in part, or used for any other
purpose without the express consent of the
manufacturer.

1.7. Rights of alteration

The manufacturer reserves the right to make
technical alterations to systems or components.
This operating and maintenance manual refers
to the waste water pump station shown on the
title page.
1.8. Warranty
This section contains the general information on
the warranty. Contractual agreements have the
highest priority and are not superseded by the
information in this section.
The manufacturer is obliged to correct any de-
fects found in the products it sells, provided that
the following requirements have been fulfilled:
1.8.1. General requirements
• The defects are caused by the materials used
or the way the product was manufactured or
designed.
• The defects were reported in writing to the
manufacturer within the agreed warranty period.
• The product was used only as prescribed.
• All safety and control devices were connected
and inspected by qualified personnel.
1.8.2. Warranty period
If no other provisions have been made, the
warranty period covers the first 12 months after
initial start-up or up to 18 months after the
delivery date. Other agreements must be made
in writing in the order confirmation. These remain
valid at least until the agreed warranty period of
the product has expired.
1.8.3. Spare parts, add-ons and modifications
Only genuine spare parts from the manufacturer
may be used for repairs, replacements, add-ons
and modifications. These are the only parts that
guarantee a long service life and maximum safety.
These parts have been specially designed for our
products. Unauthorized add-ons and modifi-
cations or the use of non-original spare parts
INTRODUCTION
WILO SE 02/2020 V4.1 DIN A4