Operation; Placing The Product; Applying Or Releasing The Wheel Locks - Stryker Altrix Handbuch

English

Placing the product

EN
When placing the product, do not block access to the hospital-grade plug or medical-grade wall outlet.
CAUTION
• Do not use Altrix located near or stacked with other medical equipment. If it is necessary to locate Altrix near other
medical equipment, make sure it operates as intended.
• Portable RF communications equipment, including peripherals such as antenna cables and external antennas,
should be used no closer than 12 inches (30 cm) to any part of Altrix system, including cables specified by the
manufacturer.
Place the Altrix controller outside of the patient environment by 1.5 m (4.9 ft)

Applying or releasing the wheel locks

The wheel locks are to help keep the product in place. The wheel lock prevents the rear caster wheels from rotating but
does not prevent the product from sliding on the floor surface.
CAUTION
Always apply the wheel locks to prevent unintended movement.
To apply the wheel locks, push down (A)
To release the wheel locks, pull up (A)
1-22

Operation

Figure 1-5: Product placement
(Figure 1-6 on page 1-22) with your foot.
(Figure 1-6 on page 1-22) with your foot.
A
Figure 1-6: Wheel locks
8001-109-005 REV B
(Figure 1-5 on page 1-22).
www.stryker.com