Stopping Therapy Or Powering Off The Product; Draining The Thermal Transfer Devices; Draining Water From The Reservoir - Stryker Altrix Handbuch

Opening and securing items in the storage compartment (Continued)
Notes
• Make sure that the items are securely inside the compartment and not blocking the magnets.
• When closing the storage compartment door, do not place your fingers between the storage compartment door and
the sides of the controller.

Stopping therapy or powering off the product

To stop therapy or power off the controller:
1. Press and hold the Stand-by button for two seconds.
2. Unplug the product from the wall outlet.
Note: If storing the product, see

Draining the thermal transfer devices

Read the manufacturer's operations manual for the individual thermal transfer devices (blankets and wraps) for
warnings, cautions, and safe operating instructions before use. Make sure that you drain the hoses before you put them
in storage.
1. Unplug the product.
2. Remove the thermal transfer device from the patient.
3. Open the clamps on the hoses and thermal transfer devices, if applicable. See
4. Raise the thermal transfer devices attached to the hose above the ports on the controller. Gravity helps to drain the
water into the controller.
5. Allow most of the water to drain back into the controller. (Approximately 10 minutes).
6. See Connecting and disconnecting thermal transfer devices on page
7. See Disconnecting the insulated hoses on page
8. See Storing the power cord and hoses on page
9. Discard the disposable thermal transfer devices based on your local waste management protocol.
a. Discard the disposable thermal transfer devices based on your local waste management protocol, if applicable.

Draining water from the reservoir

To drain the water from the reservoir:
1. See Removing and replacing the reservoir on page
www.stryker.com
Operation
Figure 1-20: Storage compartment
Storing the controller on page
1-25.
1-37.
1-27.
8001-109-005 REV B
1-37.
Figure 1-14 on page
1-25.
English
EN
1-26.
1-35