Stryker Altrix Handbuch Seite 50

English
Draining the internal water circuit and hoses for disinfection (Continued)
EN
2. Place the controller over a floor drain.
Note: For best results, the floor drain should be within reach of a wall outlet to power on the controller.
3. To drain the controller, pull up on the controller drain plug (A) to open the drain
the drain open.
4. Connect a hose to each port
5. Close the connector ends of all three hoses:
a. If you have Colder style connector hoses, attach the service tool adapter hose (8001-999-017)
page 1-42). Complete this for all three hoses.
b. If you have Clik-Tite hoses, make sure that the connector ends are connected and closed (A), and clamps are
open (B). Complete this for all three hoses.
1-42
Disinfecting
Figure 1-25: Drain plug
(Figure 1-26 on page
Figure 1-26: Hoses connected
Figure 1-27: Colder style connector hose connected to a tool adapter hose
A
1-42).
Figure 1-28 on page 1-43
8001-109-005 REV B
(Figure 1-25 on page 1-42). Leave
(Figure 1-27 on
www.stryker.com