Manual Setup - HP Smart Tank 7300-Serie Installationsanleitung

Manual Setup

1
Open the ink bottles
For ink bottles with screw-cap:
Twist open the cap.
For ink bottles with flip-cap:
Twist open the cap and remove the seal.
Replace the cap. Flip open the top of the cap.
2
Fill the ink tanks
1. Open the ink access door and tank covers.
2. Open the cap of the ink tank to be filled.
3. Place the opened bottle upside down on the tank.
The screw-cap bottle will click into place.
Let the ink drain into the tank.
4. Close the bottle cap, tank cap, and tank cover.
Repeat the above steps as needed to fill
other tanks.
5. When tanks are filled, close the ink access door
securely and wait for approximately 15 seconds.
Note: If there is leftover ink, keep the bottle upright
in a cool and dry place.
4
Make sure to close the ink access door
so the printer can detect ink,
before you install printheads.
1
3
5
2
4
15