1.
Cotter pin
1.
G o u p i l l e fendue
1.
Splint
5.
A f t e r adjusting, be sure t o tighten the
locknuts, rear wheel axle nut, sprocket
shaft nut and tension bar locknut.
6.
Insert a new cotter pin into the rear
wheel axle nut and bend the end of the
cotter pin as shown in the illustration (if
the nut notch and the cotter pin hole do
not match, loosen the nut slightly
to
match).
N O T E : — .
Excessive chain tension will
overload
the engine and other vital parts; keep
the tension w i t h i n the specified limits.
A l s o , replace the rear axle cotter
pin
w i t h a new one.
1 1 6 -