Yamaha RD250(D) Betriebsanleitung Seite 108

1. Adjuster 1. Ajusteur 1. Einstellschraube
2. Lock nut 2. E c r o u de blocage 2. Sicherungsschraube
1. Loosen the adjuster locknut (for pedal
height).
2. By turning the adjuster holt clockwise or
counterclockwise, adjust the brake pedal
position so that its top end is approx.
5 m m below the f o o t rest top end.
3. Tighten the adjuster locknut.
4. Loosen the brake rod adjuster locknut
and screw brake rod d o w n w a r d until
there is noticeable freeplay between rod
and master cylinder.
5. T u r n in the- brake rod until it lightly
touches the master cylinder, then turn it
out by approx. 1-1/2 turns (for proper
freeplay).
6. Tighten the brake rod adjuster locknut.
C A U T I O N :
The pin hole mark o n brake rod must not
show above locknut.
1. Adjuster 1. Ajusteur 1. Einstellschraube
2. L o c k nut 2. E c r o u de blocage 2. Sicherungsmutter
- 1 0 6 -