Yamaha RD250(D) Betriebsanleitung Seite 116

1. Cotter pin
2. A x l e nut
3. Sprocket shaft nut
4. L o c k nut
5. Adjusting holt
6. Marks for alignment
1. Splint
2. Achsmutter
3. Kettenrad-Schaftmutter
4. Kontermutter
5. Einstellschraube
6. Bezugsmarken für Einstell
1. G o u p i l l e
1. G o u p i l l e
2. F e r o u d'axe
3. F e r o u d'axe de pignon
4. Contre ecrou
5. E c r o u de reglage
6. Reperes de reglages
ment (There are marks on each side of
rear arm and on each chain puller; use
them to check for proper alignment).
N O T E :
Before adjusting, rotate rear wheel
through several revolutions and check
tension several times to f i n d the tightest
point. A d j u s t chain tension with rear
wheel in this " t i g h t c h a i n " position.
1 14 -