Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
44 | ORBEA
F I TTI NG THE ICR TUB E S
TO THE SWINGARM
The swingarm must be completely removed from the bike to install the ICR tubes.
1. Insert the ICR tubes from the rear of the swingarm.
the swingarm hole.
1
3
3. Apply a small amount of mild bi-component or instant
adhesive to the part of the tube that will contact the
hole in the swingarm. Orbea recommends the use of
Araldite 2022-1.
TECHNICAL MANUAL
2. Guide the ICR tubes to their corresponding outlet (same
side) on the front of the swingarm.
Leave a small part of the tube not inserted into the
swingarm.
2
4
4. Pull the ICR tubes from the front of the swingarm un-
til the tube is seated correctly and makes contact with
the outer wall of the hole in the swingarm. Immediately
wipe off any excess adhesive on the swingarm with iso-
propyl alcohol. Allow it to set according to the adhesive
manufacturer's instructions.
BLUE PAPER OIZ CARBON O M X-O M R · 2 02 3
CABLING THROUGH SIC HS02
HEADSET
Rear Brake
Dropper seatpost
ILine shock
remote
Rear derailleur
Rear Brake
ILine shock
remote
Dropper seatpost
Rear derailleur
ORBEA | 45
E N
Werbung
Inhaltsverzeichnis
