Disassembly And Disposal; 10.1 Safety Information For Disassembly And Disposal; 10.2 Disassembly; 10.3 Disposal - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

10

Disassembly and disposal

10.1 Safety information for disassembly and disposal

10.2 Disassembly

◼ Physically disconnect the control from the electrical power supply.
Before starting disassembly:
Then clean the modules and components properly and dismantle them in line with the local
regulations for occupational health and safety and environmental protection.

10.3 Disposal

◼ Scrap metals.
If no return or disposal agreement was concluded, take disassembled components for recycling:
◼ Take plastic components for recycling.
◼ Dispose of other components sorted by their material composition.
242
WARNING!
Risk of injury in the event of improper disassembly!
Improperly performed disassembly work can cause injuries.
– Before starting work, pull the mains plug and ensure that
there is sufficient space.
– Handle exposed components with sharp edges carefully.
– Ensure that the work area is clean and tidy at all times!
Components and tools lying around or on top of one another
are sources of accidents.
– Disassemble components properly.
– Please contact RK Rose+Krieger GmbH if anything is unclear.
Disposal of the control in Germany is governed by Elektro-G
(RoHS), and in the European area by EU Directive 2012/19/EC or
the respective national legislation.
Assembly instructions for the RK MultiControl II duo accu/DC control