Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 179

Initialization run
◼ When commissioning the control for the first time
Carry out an initialization run in the following circumstances:
◼ When the number of connected drives is changed
◼ When resetting the control to factory settings
◼ Connecting 2 - 8 controls in order to move drives synchronously
◼ Corresponding error message
Carry out initialization
Staff:
◼ All drives and controls are connected to each other.
Prerequisite:
1. Unplug the mains plug and wait for 30 seconds.
2.
Press and hold the
⇨ The LED display flashes red and green alternately.
3. Plug in the mains plug and wait approximately 5 seconds.
4.
Release the
5.
Press and hold the
Assembly instructions for the RK MultiControl II duo accu/DC control
⮱
The IO interface module can be connected to the RK MultiControl
II duo accu/DC using the control BUS cable supplied.
◼ User
The system must be de-energised for at least 30 seconds.
buttons at the same time.
buttons.
button until all drives have moved into the lower final position.
"Table of error messages" on page 239.
179