Connecting The Io Interface Module - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

6.4.6
IO interface module

Connecting the IO interface module

Staff:
Protective equipment:
Assembly instructions for the RK MultiControl II duo accu/DC control
Connecting the IO interface module
The IO interface module can be connected to the RK MultiControl
II duo accu/DC using the control BUS cable supplied.
Do not connect the IO interface module to direct current voltage
supplies.
The cables connected to the IO interface module must not be
longer than 30 m and must not be routed outside of buildings.
◼ Qualified electrician
◼ Protective clothing
◼ Safety shoes
Figure 29 - Connecting the control BUS cable (terminals)
175