Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 186

Figure 35 - Setting the pass-
Figure 36 - "Stroke settings"
Figure 37 - "Change basic
Figure 38 - Entering a value
186
word
menu
height" menu
Assembly instructions for the RK MultiControl II duo accu/DC control
3.
The "Control" menu is password-
protected.
Set the basic password "13121" (Figure 35).
◼ Press and hold the
4. Select the "Stroke settings" menu item:
◼ Confirm the selection with the
"Stroke settings" menu item is displayed.
⇨ The "Stroke settings" menu item (Figure 36) is
selected.
◼ Press and hold the
5. Select the "Change basic height" menu item:
◼ Confirm the selection with the
"Change basic height" menu item is displayed.
⇨ The "Change basic height" menu item (Figure 37)
has been selected.
6.
Press and hold the
height (Figure 38) has been set.
If necessary, press the
( ) to jump a digit to the right in the
parameter.
7. After changing the final digit or unit of the
⇨ The basic height has been set.
parameter, press the
buttons until the
button (
buttons until the
button (
buttons
until the basic
button
button ( ).
).
).