Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 229

Assembly instructions for the RK MultiControl II duo accu/DC control
No. Parameter
32 Drive type (e.g. 11 - Multilift II)
97 SPP threshold, collision detection, retract travel
direction [mA]:
0 - collision detection deactivated
98 SPP threshold, collision detection, extend
travel direction [mA]:
0 - collision detection deactivated
99 SPP detection direction for collision detection:
0 - up/down; 1 - up; 2 - down
100 SPP collision detection mode:
1 - Without error;
2 - Error;
3 - Automatic free-up
101 SPP collision detection mode 3 free-up
distance [inc.]
102 Low speed area before the final position in
retract travel direction [inc.].
When retracting, the drive stops in the set
position. When the
the drive continues to move at reduced speed
(parameter 14).
103 Hand switch with 2 buttons, stroke reduction
[inc.].
When moving using the hand switch with
2 buttons, the stroke is shortened in the
extend travel direction by the set number of
increments.
107 Definition of the drive type for drive group 2
◼ 0 - drive group management not
109 Definition of group classification for the drives:
◼ 2211 - drive connections 1 & 2 belong
activated
to group 1/drive connections 3 & 4
belong to group 2
111 Definition of the Hall sensor ratios from group
1 to group 2.
The parameter is set to 10000 (factor 1.0) in
the factory.
button is pressed again,
Default
Min.
(MLII)
See conf. 10
0 0
0 0
0 0
1 1
150 0
0 0
0 0
See conf. 10
0 2211
10000 2000
Max.
99
4000
4000
2
3
32000
65550
65550
99
2211
60000
229