Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 215

Assembly instructions for the RK MultiControl II duo accu/DC control
Selecting a menu
Select the menu via "Control" → "Sync BUS settings" → "Start search
1.
⇨ All connected controls are reset.
for controls" (Figure 86).
Activating the BUS connection
2.
Press the (
is correct.
⇨ The BUS connection is active.
The number of connected controls is determined and
displayed by the master control (Figure 87/
An address between 1 and 7 is assigned to each
connected slave control. This number is displayed by the
slave controls on the display screen as soon as a hand
switch is connected.
In addition, the total number of all connected drives is
determined and displayed (Figure 87/ ).
Figure 86 - Selecting a menu
) button if the number of connected controls and drives
If the number is not correct, press the
).
button ( ).
215