Material Damage - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

3.3.4
Duty cycle
Assembly instructions for the RK MultiControl II duo accu/DC control
WARNING!
Risk of crushing and shearing due to moving components!
Keep clear of moving components (e.g. height-adjustable table
frame) whose drive is positioned by the MultiControl II duo accu/
DC to avoid injuries to the hands and head.
– Before each positioning movement of the drive, make sure
that there are no persons or objects in the danger area of the
drives.
– During operation, do not handle any moving components
and do not reach into the area.
– Only carry out work on the drives when they are at a
standstill.

Material damage

NOTE!
Material damage due to overloading of the MultiControl II duo
accu/DC and/or the drives!
Exceeding the permitted duty cycle (DC) of the control can cause
material damage.
Furthermore, overloading the drives (control DC > drive DC) can
cause material damage.
– Never exceed the permissible duty cycle specified in
Section "Technical specifications" on page 244.
– Observe the duty cycle for the drives. It may be shorter
than the duty cycle of the control. The information on the
permitted duty cycle can be found on the rating plate of the
drives.
⮱
141