Commissioning" Menu; Starting The Initialization Run" Menu - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

8.5.1
Assembly instructions for the RK MultiControl II duo accu/DC control

"Commissioning" menu

8.5.1.1

"Starting the initialization run" menu

Initialization run
◼ When commissioning the control for the first time
Carry out an initialization run in the following circumstances:
◼ When the number of connected drives is changed
◼ When resetting the control to factory settings
◼ Connecting 2 - 8 controls in order to move drives synchronously
◼ Message "Start initialization" appears on the display screen
◼ Corresponding error message
"Start initialization?" message appears on the display screen
In order to move the drives, the initialization run must be
Corresponding error message Page 89
completed.
◼ The main menu for the hand switch is displayed.
Prerequisite:
187
Figure 62 - "Password" menu
⮱
"Table of error messages" on page 239
⮱
Section 8.3 on page
201