Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 225

Assembly instructions for the RK MultiControl II duo accu/DC control
Transferring parameters
2.
Press the button to transfer the settings of the control to the hand
switch memory.
Reconnecting the hand switch
3.
Disconnect the cable of the hand switch from the control.
"Connecting the hand switch" on page 167
4.
Connect the cable of the hand switch to the control to which you wish
to transfer the settings.
Transferring parameters
Select the menu via "Control" → "Parameters" → "Transfer
5.
⇨ The "Transfer parameter set" menu (Figure 101) is displayed.
parameters".
6.
Press the button to transfer the settings from the hand switch memory
⇨ The control settings have been transferred.
to the control.
Figure 100 - Selecting a menu
Figure 101 - Transferring parameters
⮱
Section
225