Bus Cable - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

Figure 5 - IO interface module
4.3.3.2

BUS cable

Figure 6 - BUS cable (examples)
A BUS cable (6 m with branch) B BUS cable (1 m)
The BUS cable is connected to the DATA interface and is used for linking
synchronous controls.
The 6 m long BUS cable (Figure 6/A) is used to link up to 8 synchronous controls.
The operator can use the branch to connect safety edges, sensors, stop inputs or
another sync BUS cable.
The 1 m long BUS cable (Figure 6/B) is used to link 2 synchronous controls.
Further information:
⮱
Section "6.4.5 Connecting the synchronisation bus" on page 173
Assembly instructions for the RK MultiControl II duo accu/DC control 151