Connecting The Accessories; Connecting The Drives To The Rk Multicontrol Ii Duo Accu/Dc - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

6.4

Connecting the accessories

6.4.1
Staff:
Protective equipment:
Prerequisite:
1.
2.
166
Before the control is connected to the power supply with the
connecting cable, connect the drives, the hand switch or other
accessories to the control.

Connecting the drives to the RK MultiControl II duo accu/DC

Two drives can be connected for each control.
Drives of the same version must be used for all controls.
◼ The mains cable must be disconnected from the power supply.
Figure 22 - Connecting the drives
Connect the cable of the first drive (Figure 22, position number 1) to drive slot
M1.
If only one drive is connected to the control, the cable must
always be connected to drive slot M1. Otherwise, the drive will
not be detected by the control.
If applicable, connect the cable of the second drive (Figure 22, position number
⇨ The drives are connected.
2) to drive slot M2.
Assembly instructions for the RK MultiControl II duo accu/DC control
◼ Assembly staff
◼ Protective clothing
◼ Safety shoes