Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 240

Code Description
"E31
- Error, slave 1 to 7
E37"
"E38" Error, serial
communication error on
control BUS
"E39" Error, serial
communication error on
sync bus
"E41" Error, limit switch
configuration (incorrect
drive)
"E42" Difference between
master and slave too
great
"E45" Internal error
"E51" A faulty entry has been
detected in the memory
"E52" Internal error
"E71" Error, drive 3 motor
current too high
"E72" Error, drive 4 motor
current too high
"E73" Blockage detected on
drive 3
"E74" Blockage detected on
drive 4
"E75" Lag error between
controller 3 and drive 3
"E76" Lag error between
controller 4 and drive 4
"E77" Difference between
drive 1 and drive 3 too
great
"E78" Difference between
drive 1 and drive 4 too
great
240
◼ Check the displayed slave control
Troubleshooting
◼ Carrying out initialization run
Hand switch is possibly faulty. Check the control - hand
switch connection.
Check the connections in the synchro system and of the
individually connected controls.
Use the appropriate drive for configuration of the control.
Drive could be faulty. Check the drive for mechanical strain.
Contact RK Rose+Krieger GmbH.
The control is automatically reset to the factory settings, carry
out an initialization run.
Contact RK Rose+Krieger GmbH.
If the error occurs frequently, check the system for
mechanical overload.
Check the system for mechanical blockages and remove them
as necessary.
Drive could be faulty. Check the drive for mechanical strain.
◼ Check the system for mechanical load
◼ Carrying out initialization run
If the error message is still displayed, the control or the drive
could be faulty.
Assembly instructions for the RK MultiControl II duo accu/DC control