Change Basic Height" Menu - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

204
8.5.2.2

"Change basic height" menu

A basic height can be used with the drives in a completely
retracted position, for example, to indicate the work surface
above the floor.
The basic height can only be changed if the unit is set to cm,
mm or inches in the "Stroke indicator unit" menu (
203).
◼ The main menu for the hand switch is displayed.
Prerequisite:
187
Selecting a menu
Select the menu via "Control" → "Stroke settings" → "Change basic
1.
height" (Figure 67).
Setting the "basic height"
⇨ A new basic height is set.
2. Set the new basic height (Figure 68).
Assembly instructions for the RK MultiControl II duo accu/DC control
Figure 66 - Entering a value
Figure 67 - Selecting a menu
⮱
Page
⮱
Section 8.3 on page