Stroke Settings" Menu; Stroke Indicator Unit" Menu - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

8.5.2
Assembly instructions for the RK MultiControl II duo accu/DC control

"Stroke settings" menu

8.5.2.1

"Stroke indicator unit" menu

The unit for the stroke indicator is set as a percentage.
The retracted position of the drives is 0 %, the extended
position is 100 %.
◼ The main menu for the hand switch is displayed.
Prerequisite:
187
Selecting a menu
Select the menu via "Control" → "Stroke settings" → "Stroke indicator
1.
unit" (Figure 65).
Setting the stroke height and unit
⇨ A new stroke height and unit are set for the stroke indicator.
2. Set the new stroke height (Figure 66) and unit (cm, mm, inches or %).
If the upper final position cannot be reached or an upward
stroke limitation is to be set, the initialization run can be
ended in any position.
To do so, press and hold the
5 seconds. The new position for the upper final position of
the drives is set.
Figure 65 - Selecting a menu
button for approximately
⮱
Section 8.3 on page
203