Deactivate Bus Connection" Menu - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

216
Carrying out initialization run
3.
Carry out an initialization run.
8.5.5.2

"Deactivate BUS connection" menu

This function deactivates the bus system so that a control can
be operated individually in the synchronisation bus.
This function cannot be activated when drive group
management is activated.
◼ The synchronisation bus is connected.
Prerequisite:
◼ The BUS connection is active.
◼ The main menu for the hand switch is displayed.
187
Assembly instructions for the RK MultiControl II duo accu/DC control
Figure 87 - Activating the BUS connection
⮱
Section 8.5.1.1 on page 201
Once the synchronisation bus has been connected,
activated and initialized, the hand switch with 2 buttons
⮱
Page 178 can also be used to operate the BUS
connection.
To do so, replace the hand switches.
⮱
Page 214
⮱
Page 167
⮱
Page 173
⮱
Section 8.3 on page