Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 155

The following drives from RK Rose+Krieger GmbH can be connected to the control:
Display/
code
10
11
12
13
20
21
30
35
44
61
81
99
* The drive code 99 is used for all customer-specific drives. The appropriate parameters
for the customer-specific drive are set by the factory for the specified control. If the
factory settings are re-loaded, the parameters set at the factory remain unchanged.
These parameters can only by overwritten by changing parameter 32. If you have
changed parameter 32, the customer-specific parameters will need to be reset before
the drive can be started up again.
Assembly instructions for the RK MultiControl II duo accu/DC control
Drive
Multilift I/Multilift synchro
Multilift II
Multilift II Telescope
Multilift II Impact
RK Slimlift
RK Slimlift EM
LZ60P
LZ60S
Drive unit LZ P
Drive unit LZ S
RK Powerlift M
Alpha Colonne
Lambda Colonne
X2 drives
Nominal Resolution
load [N] [inc/mm]
1000 2.000
3000 4.000
1000 26.000
3000 52.000
1000 25.333
3000 52.000
1000 26.000
3000 52.000
1000 10.000
4000 40.000
1000 25.333
1000 8.250
2000 16.500
3000 33.000
4000 58.667
1500 10.000
3000 40.000
4 Nm 132 inc/r
5 Nm 160 inc/r
1500 26.667
3000 40.000
1000 16
2000 22
3000 33
2000 35
4500 93.33
6000 140
Speed
[inc/s] [mm/s]
26 13.00
26 6.5
360 13.85
360 6.92
360 14.21
360 6.92
360 13.85
360 6.92
195 19.50
195 4.88
390 15.40
185 22.42
185 11.21
185 5.61
185 3.15
185 18.5
185 4.63
185 1.4015 rps
185 1.1555 rps
278 10.43
278 6.95
226 14.13
226 10.27
226 6.85
770 22
770 8.25
770 5.5
Custom
155