Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 174

1.
Connecting more than 2 controls
2.
Connecting the drives
3.
Setting the synchronisation bus
4.
174
Connect the BUS cable (Figure 27, position number 1) to the data interfaces
on the controls (Figure 27/A + B).
Figure 28 - Connecting more than 2 controls
Connect the BUS cable (Figure 28, position number 1) and terminating
resistors (Figure 28, position number 2) to the data interfaces on the controls
(Figure 28/A - C).
Make sure that the terminating resistor (Figure 28/2) is connected
directly to the DATA interface on the first (Figure 28/A, master)
and the last (Figure 28/C, slave) control.
Connect the drives to the controls
Make sure the number of connected controls and drives is correct
⇨ Connection and setting of the synchronisation bus is complete.
8.5.5 on page 214.
Assembly instructions for the RK MultiControl II duo accu/DC control
⮱
Page 166.
⮱
Section