Battery Mount - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

Assembly instructions for the RK MultiControl II duo accu/DC control
4.3.3.5

Battery mount

Figure 9 - Overview of battery mount
The battery mount is used to connect the 28 V batteries listed in the previous
section to the RK MultiControl II duo accu/DC.
The hole pattern on the battery mount is 40 x 60 mm. The battery mount can be
fixed to the Blocan profile with suitable geometry (e.g. F-40x80, F-40x80/3 etc.)
using cylinder head screws M5 x 25 mm and corresponding slot stones.
The battery mount has a 1.5 m long connecting cable with a 6-pin plug connector.
This can be connected to the power supply socket on the MultiControl II duo
accu/DC.
The batteries can be pushed onto the battery mount and locked in place.
Figure 10 - Overview of battery mount
The RK MultiControl II duo accu/DC evaluates the charge state of the fitted battery
on the basis of the voltage present. The measured charge state is displayed as a
battery symbol with 4 charging bars if a 6-button hand switch with display is
connected.
As soon as the battery voltage falls below 25 V, the active function of the control
(operation of the connected drives) is terminated and the battery symbol on the
display screen starts to flash.
153