Moving To Memory Position - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

218
Storing memory positions
2. Select the memory position (1 - 7, Figure 90) to which the current drive
position is saved.
⇨ The drive position has been saved.
3.
Press the button ( ).
8.5.6.2

Moving to memory position

◼ A memory position has been stored.
Prerequisite:
◼ The main menu for the hand switch is displayed.
187
Selecting a menu
Select the menu via "Control" → "IO interface memory positions" →
1.
"Move to memory positions" (Figure 91).
Assembly instructions for the RK MultiControl II duo accu/DC control
Figure 89 - Selecting a menu
Figure 90 - Storing memory positions
⮱
Page 217
⮱
Section 8.3 on page