Connecting The Safety Edge Provided By The Operator - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

Connecting the hand switch with 6 function keys
6.4.3
Safety edge
A safety edge provided by the operator can be connected to the RK MultiControl II duo
accu/DC and is used to safeguard against possible crushing and shearing points.
168
Alternatively, pull out the mains plug and wait for
30 seconds. Then plug in the mains plug again.
⇨ The hand switch with 2 function keys is ready for operation.
1.
Disconnect the cable of the hand switch from the hand switch
interface HS.
2. Connect the cable of the hand switch to the hand switch interface
⇨ The hand switch with 6 function keys is detected by the control
HS.
automatically and is ready for operation.

Connecting the safety edge provided by the operator

If multiple controls are operated synchronously, only use the safety
shut-off function on the master control.
Figure 24 - Connecting the BUS cable (control)
Assembly instructions for the RK MultiControl II duo accu/DC control