Phoenix Mecano RK Rose+Krieger RK MultiControl II duo accu/DC control Montageanleitung Seite 176

Prerequisite:
1.
2.
176
Figure 30 - Connecting the control BUS cable (control)
◼ The mains cable must be disconnected from the power supply.
Connect the exposed wires of the control BUS cable to the terminals (Figure
29, marked in green) of the IO interface module in accordance with the
following table:
Terminal
9
10
11
12
Connect the control bus cable (Fig. 28, position number 1) to the hand switch
⇨ Connection of the IO module is complete.
interface HS.
Assembly instructions for the RK MultiControl II duo accu/DC control
Wire colour Function
Yellow Control BUS RS485 A
Green Control BUS RS485 B
Pink Logic V+ voltage supply
9 - 15 VDC, max. 40 mA
Brown Logic GND voltage supply