Connecting The Synchronisation Bus - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

6.4.5
Synchronisation bus

Connecting the synchronisation bus

Staff:
Protective equipment:
Prerequisite:
Connecting 2 controls
Assembly instructions for the RK MultiControl II duo accu/DC control
Connecting the synchronisation bus
The synchronisation bus is used for synchronous movement of the
drives connected to the RK MultiControl II duo accu/DC control.
Up to 8 controls can be connected to each other via the DATA
interfaces using a BUS cable. A mixture of different controls can be
used.
If there are more than two connected controls, the BUS cable must
be equipped with a terminating resistor (120 Ohms) at both the
start and end.
Only controls with the same software and hardware versions can
be connected to each other
232.
◼ The mains cable must be disconnected from the power supply.
Figure 27 - Connecting the controls
◼ Assembly staff
◼ Protective clothing
◼ Safety shoes
⮱
Section ""Info" menu" on page
173