Optional Accessories; Io Interface Module; Further Information - Phoenix Mecano Rk Rose+Krieger Rk Multicontrol Ii Duo Accu/Dc Control Montageanleitung

4.3.3
The order codes for the following optional modules can be found on the RK Rose+Krieger
◼ IO interface module
GmbH website
◼ BUS cable
◼ Terminating resistor (120 Ohms)
◼ Hand switch extension cable
◼ Drives extension cable
◼ Battery mount
◼ Y cable for power-intensive drives
◼ RKX interface
◼ Hand switch cable with open end
◼ DATA interface cable with open end
◼ Adapter cable for hand switch with DIN connector
◼ Y cable for connection of two operating controls
150

Optional accessories

⮱
Section 1 on page 133:
4.3.3.1

IO interface module

The IO interface module (Figure 5) is used to activate the RK MultiControl II duo
accu/DC via discrete digital inputs (e.g. of a PLC). The IO interface module transmits
the digital inputs to the RK MultiControl II duo accu/DC control as commands and
also transmits the feedback from the control to the digital outputs. In addition, the
IO interface module transmits the serial RS485 interface of the RK MultiControl II
duo accu/DC to the digital inputs and outputs in both directions.

Further information:

⮱
Section "4.5.6 Connection configuration - IO interface module" on page 159
⮱
Section "6.4.6 Connecting the IO interface module" on page 175
Assembly instructions for the RK MultiControl II duo accu/DC control
Figure 4 - Battery