Maintenance And Cleaning; Residual Dangers; Conversions And Modifications; Qualified Personnel - HBM TIM-EC Montageanleitung

1.4

Maintenance and cleaning

The TIM-EC module is maintenance-free. Please note the following points when cleaning
the housing:
S
Before cleaning, disconnect the device from the power supply.
S
Clean the housing with a soft, slightly damp (not wet!) cloth. Never use solvents as
they could damage the labeling on the front panel.
S
When cleaning, ensure that no liquid gets into the device or connections.
1.5

Residual dangers

The scope of supply and performance of the TIM-EC covers only a small area of torque
measurement technology. In addition, system planners, installers and operators should
plan, implement and respond to the safety engineering considerations of torque mea­
surement technology in such a way as to minimize remaining dangers. On-site regula­
tions must be complied with at all times. Reference must be made to remaining dangers
associated with torque measurement technology.
Remaining dangers are indicated in these mounting instructions, see also Chapter 2
Markings used.
1.6

Conversions and modifications

The TIM-EC module must not be modified from the design or safety engineering point of
view except with our express agreement. Any modification shall exclude all liability on our
part for any damage resulting therefrom.
1.7

Qualified personnel

This device is only to be installed and used by qualified personnel, strictly in accordance
with the specifications and the stated safety rules and regulations. It is also essential to
comply with the legal and safety requirements for the application concerned during use.
The same applies to the use of accessories.
Qualified personnel means persons entrusted with siting, mounting, starting up and oper­
ating the product who possess the appropriate qualifications for their function.
S
Knowledge of the safety concepts of automation technology is a requirement and as
project personnel, you must be familiar with these concepts.
S
As automation plant operating personnel, you have been instructed how to handle the
machinery and are familiar with the operation of the equipment and technologies
described in this documentation.
S
As commissioning engineers or service engineers, you have successfully completed
the training to qualify you to repair the automation systems. You are also authorized
to activate, ground and label circuits and equipment in accordance with safety engi­
neering standards.
It is also essential to comply with the legal and safety requirements for the application
concerned during use. The same applies to the use of accessories.
TIM-EC
SAFETY INSTRUCTIONS
5