HBM TIM-EC Montageanleitung Seite 46

Dual-range - using full and partial range calibration
There are two Supporting points approximations available. This allows the the torque
transducer to be be perfectly adjusted and in tune with two different measuring ranges
(full and partial range).
Example
Measuring range 1:1
Transfer of torque to
low-pass filter 1 (TP1)
Fig. 10.16 Supporting points approximation for full and partial range calibration
The filter characteristics selected/set in accordance with menu item 3.3 Units and filters
(or section 10.3.3 "Units/Filter", page 32) from the the above screenshot are automatically
adopted.
Supporting points approximation when using the frequency signal (torque)
After switching the input mode from TMC to Frequency, the physical units in the table
automatically change to setpoint value [Nm] and actual value [Hz]. Proceed as before in
example 1 "Input of interpolation points" and example 2 "Input of interpolation gradient".
44
Measuring range 1:5 / 1:10
Transfer of torque to low-pass
filter 2 (TP2)
TIM-EC
SETTINGS