Connection To A Pc Or Network; Change Ip Address - HBM TIM-EC Montageanleitung

9

CONNECTION TO A PC OR NETWORK

You can operate the interface module either in a network or directly connected to a PC/
laptop. The interface module has an Ethernet interface (RJ45 socket) for the connection.
The TIM-EC has the default IP address 192.168.1.2 in the factory setting.
9.1

Change IP address

1. Open a web browser (e.g. Internet Explorer) and enter the current IP address, e.g.
http://192.168.1.2.
2. Under Device settings ³ Network, open the network settings and enter a new IP
address.
3. Click on Accept settings to activate the new IP address. The change takes effect
immediately. To obtain access again, you must now enter the new IP address in the
web browser.
Fig. 9.1 Network settings
18
CONNECTION TO A PC OR NETWORK
TIM-EC