10 ±5 kHz = 0 Nm ± nominal (rated) torque
60 ±30 kHz = 0 Nm ± nominal (rated) torque
240 ±120 kHz = 0 Nm ± nominal (rated) torque
The change is implemented by pressing the Save key.
Important
If measurement devices are connected to the frequency output, they must be configured to
this new output frequency range.
Notice
The analog output on the torque flange cannot be set. It is 0V ±10 V = 0 Nm ± nominal
(rated) torque.
TIM-EC
55
SETTINGS